Saturn 2010 AURA User Manual download pdf (Page 326)

• One or more TPMS sensors are missing or

damaged. The DIC message and the TPMS

malfunction light should go off when the TPMS

sensors are installed and the sensor matching

process is performed successfully. See your

dealer/retailer for service.

• Replacement tires or wheels do not match your

vehicle’s original equipment tires or wheels.

Tires and wheels other than those recommended

for your vehicle could prevent the TPMS from

functioning properly. See Buying New Tires on

page 6-60.

• Operating electronic devices or being near facilities

using radio wave frequencies similar to the TPMS

could cause the TPMS sensors to malfunction.

If the TPMS is not functioning it cannot detect or signal

a low tire condition. See your dealer/retailer for

service if the TPMS malfunction light and DIC message

comes on and stays on.

TPMS Sensor Matching Process

Each TPMS sensor has a unique identiﬁcation code.

Any time you replace one or more of the TPMS sensors

or rotate the vehicle’s tires, the identiﬁcation codes

need to be matched to the new tire/wheel location. The

sensors are matched, to the tire/wheel locations, in

the following order: driver side front tire, passenger side

front tire, passenger side rear tire, and driver side rear

tire using a TPMS diagnostic tool. See your

dealer/retailer for service.

The TPMS sensors can also be matched to each

tire/wheel position by increasing or decreasing the tire’s

air pressure. When increasing the tire’s pressure, do

not exceed the maximum inﬂation pressure indicated on

the tire’s sidewall. To decrease the tire’s air-pressure

use the pointed end of the valve cap, a pencil-style

air pressure gage, or a key.

You have two minutes to match each tire and wheel

position. If it takes longer than two minutes to match any

tire and wheel position, the matching process stops

and you need to start over.

The TPMS matching process is outlined below:

1. Set the parking brake.

2. Turn the ignition switch to ON/RUN with the

engine off.

3. Press and hold the Remote Keyless Entry (RKE)

transmitter’s LOCK and UNLOCK buttons, at the

same time, for about ﬁve seconds to start the TPMS

learn mode. The horn sounds twice indicating the

TPMS receiver is ready and in learn mode.

4. Start with the driver side front tire. The driver side

front turn signal also comes on to indicate that

corner’s sensor is ready to be learned.

6-56

1 2 ... 321 322 323 324 325 326 327 328 329 330 331 ... 427 428

Comments to this Manuals

No comments

Saturn 2010 AURA User Manual Page 326

Comments to this Manuals

Related products and manuals for Cars Saturn 2010 AURA